MaxTech NXP-16 Instrukcja Użytkownika Pobierz pdf (Strona 5)

Product data sheet Rev. 04 — 17 March 2009 5 of 29

NXP Semiconductors

PCA9532

16-bit I

C-bus LED dimmer

6. Functional description

Refer to Figure 1 “Block diagram of PCA9532”.

6.1 Device address

Following a START condition, the bus master must output the address of the slave it is

accessing. The address of the PCA9532 is shown in Figure 5. To conserve power, no

internal pull-up resistors are incorporated on the hardware selectable address pins and

they must be pulled HIGH or LOW.

The last bit of the address byte deﬁnes the operation to be performed. When set to logic 1

a read is selected, while a logic 0 selects a write operation.

6.2 Control register

Following the successful acknowledgement of the slave address, the bus master will send

a byte to the PCA9532, which will be stored in the Control register.

The lowest 4 bits are used as a pointer to determine which register will be accessed.

If the Auto-Increment (AI) ﬂag is set, the four low order bits of the Control register are

automatically incremented after a read or write. This allows the user to program the

registers sequentially. The contents of these bits will rollover to ‘0000’ after the last

When Auto-Increment ﬂag is set (AI = 1) and a read sequence is initiated, the sequence

must start by reading a register different from the INPUT0 register

(B3 B2 B1 B0 ≠ 0000).

Only the 4 least signiﬁcant bits are affected by the AI ﬂag. Unused bits must be

programmed with zeroes.

Fig 5. PCA9532 slave address

002aac505

1 1 0 0 A2 A1 A0 R/W

fixed

slave address

hardware

selectable

Reset state: 00h

Fig 6. Control register

002aae523

0 0 0 AI B3 B2 B1 B0

Auto-Increment flag

1 2 3 4 5 6 7 8 9 10 ... 28 29

Vikivtx 04 Jan 2024 | 11:57:49

urenrjrjkvnm

Serzicp 11 Jan 2024 | 20:01:40

coin

MaxTech NXP-16 Instrukcja Użytkownika Strona 5